Every Hi-Lift Mount/Clamp uses MALE DIAMOND KNURLS for a secure hold on the tube you are clamping.
A male diamond knurl helps hold the clamp in both directions from moving. We use two ¼-20 SHCS to hold the two pieces together. This clamp can be mounted on any size tubing listed above. This is a clean way to mount your Hi-Lift on your roll cage, bumper or any other tubing.
You simply take each half of the clamp and bolt each side around the tubing where you want your Hi-Lift to be mounted and tighten the supplied bolts. Then set your Hi-Lift Jack on the two studs protruding from the clamps and use the supplied wing nut to secure your Hi-Lift to the clamp.
We machine these Hi-Lift Clamps/brackets in house from 6061-T6 billet aluminum. Every AJK Offroad part is proud to be designed and manufactured in the USA.
Justis Dastrup (verified owner) –
Installed on my Jeep tire carrier with 1.75″ diameter tubing. Couldn’t have been easier or more secure, all you need is an allen wrench. Price is slightly lower than similar quality products, and has a minimalist design that looks clean and doesn’t have the jack protruding out from the mounting surface as far as other products out there. Each bracket comes with 2 washers that sandwich the jack and provide a secure, rattle free surface. The only thing I added was a lock washer before spinning on the wing nut to make sure the nut didn’t rattle loose on the trail.
Joe Driskill –
High Lift Jack Mounts are awesome. I bought 2 and mounted my Jack on the rear bumper and I can still open the tailgate!
Joe Driskill –
“Forgot to mention what vehicle I put them on” High Lift Jack Mounts fit the Bumper of my 2014 Midsized Polaris Ranger perfect!
No where to post a photo or I would have.